Header Ads

How to Use Wismec SINUOUS V80 -User Manual

How to use SINUOUS V80: 



1. Power on/off: Push forward the battery cover and put one high-rate 18650 cell into the battery body. Press the fire button 5 times in quick succession turn the device on and off.

Note: (1). Please adjust the wattage to a proper range to match the atomizer you used before using. (2). Please be careful not to use battery with torn shell for safety.

2. Stealth function: While the device is on, simultaneously hold the fire button and the left regulatory button. This will switch the screen display on and off.

3. Key lock function: While the device is on, simultaneously press the two regulatory buttons. This will switch between Key Lock and Key Unlock function.

4. Switch the display mode: By pressing the left and right regulatory buttons simultaneously in shutdown state, the screen display will rotate 180 degrees. You can then view the screen from two kinds of angle through this operation.


Wismec SINUOUS V80 Mod Instructions

Shift among VW/Bypass/TC-Ni/TC-Ti/TC-SS/TCR Mode

When the device is on, press the fire button 3 times in quick succession, then press the left or right regulatory button to shift among VW/Bypass/TC-Ni/TC-Ti/TC-SS/TCR Mode.

Wattage Adjustment: Under VW mode, the output wattage can be adjusted from 1W to 80W by pressing the regulatory buttons, right to increase and left to decrease.
Shift among Current,

Puff and Time: Under VW mode, keep pressing the fire button and right regulatory button, and then the user information sign will blink. Press the left or right regulatory button to shift among current, puff and time.


Malfunction Indication and Protection: 


No Atomizer Alert: When the device does not detect an atomizer, the OLED screen will display “No Atomizer Found”.

Atomizer Low Alert: When the resistance of atomizer is lower than 0.05ohm, the OLED screen will display “Atomizer Low”.

Atomizer Short-circuit Protection: When atomizer short-circuit occurs, the OLED screen will display “Atomizer Short”.

Over 10 Second Protection: When the fire button is pressed for over 10 seconds, the output will shut off and the OLED screen will display “Over 10s Protection”.

Low-voltage Protection: When the voltage of the battery is below 3.3V, the screen will display “Weak Battery”. Then please charge the battery to unlock the device.

No comments

Powered by Blogger.