Wismec SINUOUS RAVAGE230 Instruction - Vape Guide

How to use SINUOUS RAVAGE230:

1. Power on/off: 

Push forward the battery cover and put two high-rate 18650 cells into the battery body. Press the fire button 5 times in quick succession to turn the device on and off.

Note: 

(1). Please adjust the wattage to a proper range to match the atomizer you used before using.
(2). Please be careful not to use battery with torn shell for safety.

2. Display on/off function: 

While the device is on, press the Fn button, this will turn the screen display on/off. When the display is off, regulatory buttons will not work to prevent accidental adjustments.

3. Key lock function: 

While the device is on, simultaneously press the two regulatory buttons. This will switch between Key Lock and Key Unlock function.

4. Micro USB port function: 

The USB port can be used for charging and upgrading firmware. It is better to take out the cells and charge them through external charger.

5. Switch the display mode:

 By pressing the left and right regulatory buttons simultaneously in shutdown state, the screen display will rotate 180 degrees. You can then view the screen from two kinds of angle through this operation.

General Settings:

1. When the device is on, press the fire button 3 times in quick succession to enter the main menu.

2. Press the left or right regulatory button once repeatedly to shift among
(1) MODE, (2) SETTINGS and (3) INFO. Press the fire button to confirm. Under their sub-menus, you can choose vaping mode, set parameters, turn on/off certain functions and so on in the same way (press the left or right regulatory button to adjust and press the fire button to confirm).

3. After settings are complete, just move the EXIT or press the Fn button to go back to the main interface.