Header Ads

Eleaf iCare 110 Use Manual something you need to know

The iCare 110, a new starter kit by Eleaf, is 11mm in diameter with an inbuilt tank that has a leakproof bottom design. It is quite easy to use and convenient to carry because of its simple structure and tiny size. The e-liquid can easily be refilled by unscrewing the top cap. To power it on or off or to activate the tank can both be done simply by holding the button. The iCare 110 also comes in various colors for your choice.

Something you need to know:

How to Use? 

1. Assembling: 

A How to assemble: Screw the IC 1.1ohm Head onto the top cap tightly and then screw the top cap with atomizer head into the tank.
B How to fill e-liquid:
1). First unscrew the top cap off the tank;
2). Then slowly fill the e-liquid into the tank;
3). Finally screw the top cap with atomizer head into the tank again. Note: 1. Please don't fill beyond the Max mark to avoid overfill. 2. Please first drip a few drops of e-liquid directly into the coil to make it fully saturated before first use.

2. Power on/off:

Press the button 5 times in quick succession within 1.5 seconds, the white button light will flash 3 times to show the iCare 110 is ready to use. In the same way, iCare 110 can also be turned off.
Vaping: When the device is powered on, long press the button to take a puff.
Charging: Charge the iCare 110 by connecting it with 0.5A wall adapter or computer via USB cable. The white button light turns on when the device is charging. When the device is fully charged, the light flashes 20 times and then goes out.

3. Properties and Protections: 

Atomizer Protection: Each time when vaping time exceeds 10 seconds, the button light flashes 8 times and the output cuts off automatically.
Short Circuit Protection: If short circuit occurs before vaping, the button light will flash 3 times quickly and the output cuts off automatically when you start to vape; if short circuit occurs during vaping, the button light will flash 3 times slowly.
Low Voltage Protection: When the voltage of the device is lower than 3.3V, the button light flashes 10 times and there will be no output. Charge the device to reactivate it.
Resistance Detect: If the output load resistance is lower than 1.0ohm, there will be no output when you press the button to vape.
Know more informations about Eleaf iCare 110 Vape Pen kit at http://www.istick.org/eleaf-icare-110-starter-kit.html

No comments

Powered by Blogger.